ГОСТ 22-11-2.5 Enquiry | Print this page
Category | Type | Steel grade | Standard | Country |
---|---|---|---|---|
Grades | Special Alloy | 22-11-2.5 | ГОСТ | Russia |
Chemical composition % of the ladle analysis of grade 22-11-2.5
C(%) | Si(%) | Mn(%) | P(%) | S(%) | Cr(%) | Ni(%) | W(%) | Ti(%) |
---|---|---|---|---|---|---|---|---|
0.10- 0.25 | 0.6-1.5 | 0.6-1.2 | Max 0.025 | 0.025 | 20.0- 23.0 | 10.5- 12.5 | 2.4- 3.0 | Max 0.2 |
22-11-2.5
Proof strength Rp0.2 (MPa) |
Tensile strength Rm (MPa) |
Impact energy KV (J) |
Elongation at fracture A (%) |
Reduction in cross section on fracture Z (%) |
As-Heat-Treated Condition | Brinell hardness (HBW) |
---|---|---|---|---|---|---|
393 (≥) | 924 (≥) | 41 | 13 | 14 | Solution and Aging, Annealing, Ausaging, Q+T,etc | 432 |
Property | Density kg/dm3 |
Temperature T °C/F |
Specific heat J / kgK |
Thermal conductivity W/mK |
Electric resistance µΩ·cm |
Modulus of elasticity kN/mm2 |
Expansion rate |
---|---|---|---|---|---|---|---|
152 (≥) | 895 (≥) | 24 | 32 | 43 | Solution and Aging, Annealing, Ausaging, Q+T,etc | 123 | |
Temp. °C/°F |
Creep strain limit (10000h) (Rp1,0) N/mm2 |
Creep rupture strength (10000h) (Rp1,0) N/mm2 |
|||||
155 | 896 | 554 |
Product type | Products | Dimension | Processes | Deliver Status |
---|---|---|---|---|
Plates / Sheets | Plates / Sheets | 0.08-200mm(T)*W*L | Forging, hot rolling and cold rolling | Annealed, Solution and Aging, Q+T, ACID-WASHED, Shot Blasting |
Steel Bar | Round Bar, Flat Bar, Square Bar | Φ8-1200mm*L | Forging, hot rolling and cold rolling, Cast | Black, Rough Turning, Shot Blasting, |
Coil / Strip | Steel Coil /Steel Strip | 0.03-16.0x1200mm | Cold-Rolled & Hot-Rolled | Annealed, Solution and Aging, Q+T, ACID-WASHED, Shot Blasting |
Pipes / Tubes | Seamless Pipes/Tubes, Welded Pipes/Tubes | OD:6-219mm x WT:0.5-20.0mm | Hot extrusion, Cold Drawn, Welded | Annealed, Solution and Aging, Q+T, ACID-WASHED |
Grade | Standard | Country | Application |
---|---|---|---|
22-11-2.5 | ГОСТ | Russia | Russia TY standard grades and chemical compositions of the high temperature alloy castings |
1Cr18Mn10Ni5Mo3N | ГОСТ | Russia | Of urea with good corrosion resistance, can produce urea corrosion of the equipment. |
1Cr17Mn6Ni5N | ГОСТ | Russia | Nickel steel grade, instead of number 1 cr17ni7 and magnetism after cold working, used in railway vehicle, etc |
1Cr18Mn8Ni5N | ГОСТ | Russia | Nickel steel, instead of 1cr18ni9 |
0Cr25Ni20 | ГОСТ | Russia | Oxidation resistance is better than 0cr23ni13. Mostly used as heat resistant steel |
A-29 1025 | ГОСТ | Russia | General use carbon steel rod |
1025 | ГОСТ | Russia | These products have been used typically for use in fabrication of fittings, but usage is not limited to such applications. These products are not typically used for deep forming or cupping operations. |
G10250 | ГОСТ | Russia | General use carbon steel rod |
G2500 | ГОСТ | Russia | Used in the products of the automobile, truck, tractor, and allied industries; small cylinder blocks, cylinder heads, air cooled cylinders, pistons, clutch plates, oil pump bodies, transmission cases, gear boxes, clutch housings, and light-duty brake drum |
F10005 | ГОСТ | Russia | Used in the products of the automobile, truck, tractor, and allied industries; small cylinder blocks, cylinder heads, air cooled cylinders, pistons, clutch plates, oil pump bodies, transmission cases, gear boxes, clutch housings, and light-duty brake drum |
G2500a | ГОСТ | Russia | Used in the products of the automobile, truck, tractor, and allied industries |
G3500 | ГОСТ | Russia | Used in the products of the automobile, truck, tractor, and allied industries |
G3500b | ГОСТ | Russia | Diesel engine cylinder block, truck and tractor cylinder block and cylinder head, flywheel, tractor transmission case and heavy-load gear box |
G3500c | ГОСТ | Russia | Used in the products of the automobile, truck, tractor, and allied industries |
W5 | ГОСТ | Russia | Carbon tool steel |
T72305 | ГОСТ | Russia | Carbon tool steel |
A5 | ГОСТ | Russia | Alloy tool steel |
00Cr17Ni14Mo2 | ГОСТ | Russia | Austenitic stainless steel. Grade 00Cr17Ni14Mo2 was replaced by new designation 022Cr17Ni12Mo2 according to GB/T 20878 (2007) |
X2CrNiMo18-14-3 | ГОСТ | Russia | Austenitic stainless steel. Grade 00Cr17Ni14Mo2 was replaced by new designation 022Cr17Ni12Mo2 according to GB/T 20878 (2007) |
1.4435 | ГОСТ | Russia | Austenitic stainless steel. Grade 00Cr17Ni14Mo2 was replaced by new designation 022Cr17Ni12Mo2 according to GB/T 20878 (2007) |
Relevant products
-
SKD-11 Cold working die steel
-
X165CrMoV12 Cold working die steel
-
A387 F5 / Grade 5 Coil / Sheet
-
T30402/X155CrVMo121 Die Steel Sheet
-
1.4980 Round Bar
-
DT413 / 4Cr5MoSiV1MOD
-
45Cr14Ni14W2Mo forging
-
GH 3536 Sheet
-
X65Cr13 profile steel
-
4145H Hollow Bar
-
95CrV / 9CrV strip steel
-
L605 Round Bar Stock
-
Inconel625 round bar
-
Incoloy825 round bar
-
NO8825 round bar
-
Inconel825 round bar
-
NO8020/No8031/N08367/NO8810/NO8825 Forging
-
GH 3536 Sheet
-
Inconel 625 Bar
-
GH 605
22-11-2.5 Equivalent Grade Stock
Steel grade | Dimension | Shape | Unit | Quantity | Delivery state | Query |
---|---|---|---|---|---|---|
Cr12MoV | 12-160(T)*310-610(W)*L | Plate or Sheet | Tons | 12.38 | Hot-Rolled+Annealed+black | Enquiry |
1.2601 | 12-160(T)*310-610(W)*L | Plate or Sheet | Tons | 11.22 | Hot-Rolled+Annealed+black | Enquiry |
A387 F5 & Grade 5 sheet Coil strip | 0.5mmx200mmxC | Coil or Strip | Tons | 3 | Cold-Rolled+Annealed | Enquiry |
A387 F5 & Grade 5 Hot Coil stock | Select | Tons | 3 | Hot-Rolled+Annealed+black | Enquiry | |
T45Cr5Si3 Round Bar | Dia.40mm | Round Bar | Kgs | 500 | Hot-Rolled+Annealed+black | Enquiry |
1.2344(H13/X40CrMoV5-1/Z40CDV5) Stock List | Dia.182mm - Dia.510mm | Round Bar | Tons | 120 | Forged+Annealed+black | Enquiry |
1.2714 Hot-Work Mould Steel Flat Bar Stock(2019-09-03) | Select | 0 | Select | Enquiry | ||
15-5PH Forgrd Flat Bar | Select | 0 | Select | Enquiry | ||
1.2714 Stock list 2020-06-15 | Select | 0 | Select | Enquiry | ||
1.2714 QT Bar Stock List 2020-06-15 | Select | 0 | Select | Enquiry |