SAE G2500a Enquiry | Print this page
SAE G2500a Details
Brake drums and clutch plates for moderate service requirements, where high carbon iron is desired to minimize heat checking. Lamellar pearlite ferrite if present not to exceed 15%.
SAE G2500a Standard Download
G2500a Datasheet
SAE G2500a| Category | Type | Grade | Microstructure | Designations |
|---|---|---|---|---|
| Grades | Cast Iron and Cast Steel | G2500a | Ferrite-Pearlitic | USA - SAE , ASTM A 159 (1983) - Automotive gray iron castings |
| Elements | Min.（≥） | Max.（≤） | Similar | Remarks |
|---|---|---|---|---|
| C | - | 3.40 | ||
| Si | 1.60 | 2.10 | ||
| Mn | 0.60 | 0.90 | ||
| P | - | 0.15 | ||
| S | - | 0.12 |
| Proof strength Rp0.2 (MPa) |
Tensile strength Rm (MPa) |
Impact energy KV (J) |
Elongation at fracture A (%) |
Reduction in cross section on fracture Z (%) |
As-Heat-Treated Condition | Brinell hardness (HBW) |
|---|---|---|---|---|---|---|
| 791 (≥) | 157 (≥) | 12 | 11 | 31 | Solution and Aging, Annealing, Ausaging, Q+T,etc | 313 |
| Property | Density kg/dm3 |
Temperature T °C/F |
Specific heat J / kgK |
Thermal conductivity W/mK |
Electric resistance µΩ·cm |
Modulus of elasticity kN/mm2 |
Expansion rate |
|---|---|---|---|---|---|---|---|
| 523 (≥) | 911 (≥) | 14 | 43 | 42 | Solution and Aging, Annealing, Ausaging, Q+T,etc | 311 | |
| Temp. °C/°F |
Creep strain limit (10000h) (Rp1,0) N/mm2 |
Creep rupture strength (10000h) (Rp1,0) N/mm2 |
|||||
| 962 | 174 | 163 |
| Product type | Products | Dimension | Processes | Deliver Status |
|---|---|---|---|---|
| Plates / Sheets | Plates / Sheets | 0.08-200mm(T)*W*L | Forging, hot rolling and cold rolling | Annealed, Solution and Aging, Q+T, ACID-WASHED, Shot Blasting |
| Steel Bar | Round Bar, Flat Bar, Square Bar | Φ8-1200mm*L | Forging, hot rolling and cold rolling, Cast | Black, Rough Turning, Shot Blasting, |
| Coil / Strip | Steel Coil /Steel Strip | 0.03-16.0x1200mm | Cold-Rolled & Hot-Rolled | Annealed, Solution and Aging, Q+T, ACID-WASHED, Shot Blasting |
| Pipes / Tubes | Seamless Pipes/Tubes, Welded Pipes/Tubes | OD:6-219mm x WT:0.5-20.0mm | Hot extrusion, Cold Drawn, Welded | Annealed, Solution and Aging, Q+T, ACID-WASHED |
| Grade | Standard | Country | Application |
|---|---|---|---|
| G2500a | SAE | USA | Used in the products of the automobile, truck, tractor, and allied industries |