Get Appoinment
Location » Home » Grades > Special Alloy > EN P500Q1.2

EN EN P500Q1.2 Enquiry | Print this page

EN P500Q1.2 Application:Euronorm Structural steel
Category Type Steel grade Standard Country
Grades Special Alloy EN P500Q1.2 EN Euronorm

Chemical composition % of the ladle analysis of grade EN P500Q1.2

C(％) Si(％) Mn(％) P(％) S(％) Cr(％) Ni(％) Mo(％)
0.18 0.60 1.70 0.020 0.010 1.00 1.50 0.70
Euronorm Structural steel, EN P500Q1.2
Mechanical properties of grade EN P500Q1.2
Proof strength
Rp0.2 (MPa)		 Tensile strength
Rm (MPa)		 Impact energy
KV (J)		 Elongation at fracture
A (%)		 Reduction in cross section on fracture
Z (%)		 As-Heat-Treated Condition Brinell hardness (HBW)
382 (≥) 359 (≥) 21 42 24 Solution and Aging, Annealing, Ausaging, Q+T,etc 331
Physical properties of grade EN P500Q1.2
Property Density
kg/dm3		 Temperature T
°C/F		 Specific heat
J / kgK		 Thermal conductivity
W/mK		 Electric resistance
µΩ·cm		 Modulus of elasticity
kN/mm2		 Expansion rate
317 (≥) 769 (≥) 34 42 41 Solution and Aging, Annealing, Ausaging, Q+T,etc 423
Temp.
°C/°F		 Creep strain limit
(10000h)
(Rp1,0) N/mm2		 Creep rupture strength
(10000h)
(Rp1,0) N/mm2
882 936 279
EN P500Q1.2 Range of products
Product type Products Dimension Processes Deliver Status
Plates / Sheets Plates / Sheets 0.08-200mm(T)*W*L Forging, hot rolling and cold rolling Annealed, Solution and Aging, Q+T, ACID-WASHED, Shot Blasting
Steel Bar Round Bar, Flat Bar, Square Bar Φ8-1200mm*L Forging, hot rolling and cold rolling, Cast Black, Rough Turning, Shot Blasting,
Coil / Strip Steel Coil /Steel Strip 0.03-16.0x1200mm Cold-Rolled & Hot-Rolled Annealed, Solution and Aging, Q+T, ACID-WASHED, Shot Blasting
Pipes / Tubes Seamless Pipes/Tubes, Welded Pipes/Tubes OD:6-219mm x WT:0.5-20.0mm Hot extrusion, Cold Drawn, Welded Annealed, Solution and Aging, Q+T, ACID-WASHED
Cross Reference Table(Equivalent Grade)
Grade Standard Country Application
1Cr18Ni12 EN Euronorm
Compared with 0 cr19ni9, processing low hardenability. Used for spinning processing, special drawing, cold heading
0Cr23Ni13 EN Euronorm
Corrosion resistance and heat resistance are better than 0cr19ni9
0Cr25Ni20 EN Euronorm
Oxidation resistance is better than 0cr23ni13. Mostly used as heat resistant steel
0Cr17Ni12Mo2 EN Euronorm
Seamless stainless steel tubes for boiler and heat exchanger
1Cr18Ni12Mo2Ti EN Euronorm
Seamless stainless steel tubes for boiler and heat exchanger
0Cr18Ni12Mo2Ti EN Euronorm
Seamless stainless steel tubes for boiler and heat exchanger
A-29 1025 EN Euronorm
General use carbon steel rod
1025 EN Euronorm
These products have been used typically for use in fabrication of fittings, but usage is not limited to such applications. These products are not typically used for deep forming or cupping operations.
G10250 EN Euronorm
General use carbon steel rod
1026 EN Euronorm
Nonresulfurized carbon steels
G10260 EN Euronorm
This grade is a carbon steel composition applicable only to structural shapes (sections), plates, strip, sheets, and welded tubing.
T72301 EN Euronorm
Carbon tool steel products which include hot or cold finished bar, plate, sheet, rod, wire, or forgings, which are normally fabricated into tools, dies, or fixtures.
W2-A EN Euronorm
Carbon tool steel products which include hot or cold finished bar, plate, sheet, rod, wire, or forgings, which are normally fabricated into tools, dies, or fixtures.
T72302 EN Euronorm
Carbon tool steel products which include hot or cold finished bar, plate, sheet, rod, wire, or forgings, which are normally fabricated into tools, dies, or fixtures.
G2500 EN Euronorm
Used in the products of the automobile, truck, tractor, and allied industries; small cylinder blocks, cylinder heads, air cooled cylinders, pistons, clutch plates, oil pump bodies, transmission cases, gear boxes, clutch housings, and light-duty brake drum
G2500a EN Euronorm
Used in the products of the automobile, truck, tractor, and allied industries
F10012 EN Euronorm
Used in the products of the automobile, truck, tractor, and allied industries. Diesel engine castings, liners, cylinders, and pistons.
W2-C EN Euronorm
Carbon tool steel products which include hot or cold finished bar, plate, sheet, rod, wire, or forgings, which are normally fabricated into tools, dies, or fixtures.
T72305 EN Euronorm
Carbon tool steel
201 EN Euronorm
Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater, and Heat-Exchanger Tubes

Relevant products

EN P500Q1.2 Equivalent Grade Stock

Steel grade Dimension Shape Unit Quantity Delivery state Query
D2 Round bar Φ25-Φ380mm Round Bar Kgs 45325 Hot-Rolled+Annealed+black Enquiry
Cr12MoV 12-160(T)*310-610(W)*L Plate or Sheet Tons 12.38 Hot-Rolled+Annealed+black Enquiry
1.2601 12-160(T)*310-610(W)*L Plate or Sheet Tons 11.22 Hot-Rolled+Annealed+black Enquiry
IncoloyA-286 / GH 2132 Stock Φ8-65mm*L Round Bar Kgs 489 Hot-Rolled+Annealed+black Enquiry
X22CrMoV12-1 / 1.4923 Φ17mm Round Bar Kgs 300 Hot-Rolled+Annealed+black Enquiry
1.2083 Forged Plate T:105-185mm*W:510*L Plate or Sheet Tons 26 Forged+QT Enquiry
X22CrMoV12-1 / 1.4923 Φ30mm Round Bar Kgs 300 Hot-Rolled+Annealed+black Enquiry
1.4882 strip/sheet/plate stock 3.5x200x1000-2000mm Coil or Strip Kgs 200 Cold-Rolled+Annealed Enquiry
SA-437 Grade B4B/SUS 616 /422 Forged Bar Dia.160xL Round Bar Kgs 2120 Forged+QT Enquiry
1.2344(H13/X40CrMoV5-1/Z40CDV5) Stock List Dia.182mm - Dia.510mm Round Bar Tons 120 Forged+Annealed+black Enquiry
1.2344 ESR Round Bar Stock List(2019-9-3) Select 0 Select Enquiry
Stainless Steel 422 / Alloy 422 AMS 5655 UNS S42200/616/B4B Round Bar Stock Select 0 Select Enquiry
1.2343 ESR Stock list(2019-09-03) Select 0 Select Enquiry
1.2367 ESR Forged Round Bar stock(2019-09-03) Select 0 Select Enquiry
1.2379 ESR Round Bar Stock(2019-09-03) Select 0 Select Enquiry
1.2714 Hot-Work Mould Steel Flat Bar Stock(2019-09-03) Select 0 Select Enquiry
1.2714 Stock list 2020-06-15 Select 0 Select Enquiry
1.2344 Stock List 2020-06-15 Select 0 Select Enquiry
1.2714 QT Bar Stock List 2020-06-15 Select 0 Select Enquiry
1Cr11Ni2W2MoV,961,13Cr11Ni2W2MoV Sheet Select 0 Select Enquiry

Enquiry